User manual
48
www.3onedata.com
ID is 2, Ring Type is Single.
5. Use a wire to connect Port 4 and 5 of Device 100-104 in turn to make a Single Ring. Use a wire to
connect Port 1 and 2 of Device 105-109 in turn to make a Single Ring. Then use a wire to connect
Port 4 of Device 106 to Port 1 of Device 101, Port 4 of Device 105 to Port 1 of Device 100. The
Coupling Ring is completed.
Control port as shown figure, device 105 and the device 106 connected to two ports, device 100 and
device 101 is connected to two ports two, also known as the control port.
Chain Configuration
Chain ring structure figure as below
Operating method:
1. Enable Ring Group 1: Hello time can be disable too, if it enable, time of sending Hello packet could
not be very fast, or it will influence CPU dealing speed.
2. Set up Port 7 and 8 of Device 100, 101, 102 and 103 to be Ring Port in Ring Group 1, Network ID is1,
Ring Type is Single. Set up Port 7 and 8 of Device 107, 108 and 109 to be Ring Ports in Ring Group 2,
Network ID is 2. Ring Type is Chain.
3. Use a wire to connect Port 7 and 8 of Device 107-109 in turn to make a chain. Use a wire to connect
Port 7 and 8 of Device 100-103 in turn to make a Single Ring, Then use a wire to connect Port 8 of
Device 107 and Port 7 of Device 109 to normal port of Device 102 and 103. Chain is finished.
Node configuration steps:
Step 1: select 1, 2, 3 or 4 in the drop-down box in the ring network group;
Step 2: in the ring network identification of the text box to fill in the network identification;
Step 3: select Single, Couple, Chain, or Dual_homing in the drop-down box of the ring network type;
Step 4: select the port in the drop - down box on the ring network port 1;
Step 5: in the ring network port 2 in the drop-down box to select the port, and cannot be the same as the
ring network port 1;
Step 6: fill in the value of the Hello Time in the Hello Time text box;
Step 7: click the "add" button.