6 Physical Characteristics
Hardware interfaces
Models SE and DL
both numerically and graphically. This is explained in further detail in
Chapter 2, “The Display and keypad”).
Hardware interfaces
The Hardware Interface Panel, shown in Figure 1- 4, is located under a
hinged cover in the base of the instrument. The cover can be lifted by a tab
at one side, and snapped shut again by closing and pressing firmly at the
center.
Figure 1-4: Hardware Interface Panel
Memory card slot
A Secure Digital (SD) removable memory card is shipped with each
SoundPro SE/DL instrument. The card should always be in place when you
are operating the instrument. More information about operating with the
memory card is given under “Memory card” on page 106.
NOTE: You must use a compatible SD card. For information about
replacing the SD card, see “Compatibility” on page 117.
USB port
A USB cable is shipped with each SoundPro SE/DL instrument. One end fits
the mini B port in the instrument. The other end fits a standard USB
connector on a personal computer. A USB connection to a personal
computer allows files to be transferred, settings to be downloaded to the
instrument, and post- session analysis to be performed in the computer using
data files created in the instrument.
Summary of Contents for SP-SE-2-1/1
