3M SCPFXWMV2, Installation Instructions Manual

Page: 6 / 90

6 © 2009 3M. All Rights Reserved.
3M ™ Fixed Wall Mount SCPFXWMV2
En
gl
ish
Stud walls:
Mark the holes at the center of the studs and then
using a 3/16" (5 mm) bit, drill 4 holes 1-1/2" (38 mm)
deep through the wall into the studs.
4X
1/2–5/8"
(13–16 mm)
4.5 Using a 3/8" socket, attach the bracket to the wall
using 4 short mounting lag bolts.
5.0 Route Cables
5.1 Feed power, VGA and USB cables through the base
section of the arm. Bundle the cables and secure
about 6 inches (150 mm) from the end using a
cable tie.
~6"
(150 mm)
Note: The optional control cable is shipped with the
3M ™ I/O Module.
6.0 Install Security Kit (Optional)
6.1 Attach the optional security cable by either locking
it to the mounting bracket security slot (1), looping
it through the mounting bracket (2) or looping it
through screw-mount anchor point (3).
1 2 3
Note: If using the screw-mount anchor point, secure the
anchor point before attaching the cable.
6.2 Feed the security lock cable through the arm. Secure
about 6 inches (150 mm) from the end of the existing
cable bundle using a cable tie.
~6"
(150 mm)
7.0 Mount Base to Wall
7.1 Position the wall mount over the mounting screw
anchors or mounting bracket. Install and tighten the
4 mounting screws/mounting lag bolts firmly.