3M Peltor WS Lite-Com, User Manual

Page: 11 / 314

8 9
TECHNICAL DATA
ATTENUATION (SNR) (Fig.D)
The headset is tested and CE approved as a hearing protector in accordance with the PPE directive 89/686/EC and the
European standards EN 352-1:2002, EN 352-3:2002, EN 352-4:2001, EN 352-6:2002 and EN 352-8.
Certified by FIOH, Topeliuksenkatu 41, FI-00250 Helsinki, Finland (Notified Body number 0403).
Explanation of the attenuation data table :
1. Frequency (Hz)
2. Average attenuation (dB)
3. Standard deviation (dB)
4. Expected deviation (dB)
A list of possible headset/helmet combinations can be found in appendix A .
EXTERNAL INPUT SIGNAL/OPERATING TIME (Fig. E)
Warning: The sound output from the speakers inside the cups may exceed the permitted exposure level. The audio
signal must be adjusted to suit the exposure time. To prevent harmful effects, the input signal should not exceed 30 mV.
At a higher input voltage, the operating time must be decreased according to diagram E:1 (x=30 mV). An electrical input
signal of 30 mV(RMS) corresponds to 82 dB (A) equivalent sound level (average value plus one standard deviation of the
measured sound level. See table E:2). Notice: The maximum output effect of the earphones must not be exceeded.
BLUETOOTH
Bluetooth 2.1 + EDR
A2DP 1.2
HSP 1.5
HFP 1.5
RADIO
EN 300 296-2 V1.2.1 (2009-02)
EN 300 328 V1.7.1 (2006-10)
EMC
EN 301 489-1 V1.8.1 (2008-04)
EN 301 489-5 V1.3.2 (2008-04)
EN 301 489-17 V1.3.2 (2008-04)
LVD
EN 60950: 2006
The measurements were performed by BACL, Shenzhen, Guangdong, China
RECHARGEABLE BATTERY ACK051
EN60950:2006 Low Voltage Dir amendment A11:2009
The measurements were performed by Timeway Testing Laboratory, Hong Kong
DECLARATION OF CONFORMITY
3M Svenska AB hereby declares that this WS Peltor Lite-Com is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC. See also full copy of Declaration of Conformity on page 307 .