78-8130-6150-0-F
19
D. Enabling/Disabling Frequencies
MENU [6] + >>More [SK:4] + Setup [SK:6] + >>More [SK:6d] + Locate Freq [SK:6g]
The user can select the frequencies that the receiver will detect. All the available
frequencies are listed in four groups (Left to Right: Active, Power, Passive, and
Auxiliary). The Auxiliary group also contains the User Defined Frequencies. (
See
Creating User Defined Frequencies, Section 5F.
)
1. Press the right arrow [SK] to move the highlight
bar to the section of frequencies to enable, or
disable.
2. Press the up/down arrows [SK] to highlight the
specific frequency.
3. Press
Enabl/Disabl
[SK]. (Enable denoted by
3
)
4. Repeat steps 2 & 3 to enable/disable other
frequencies.
5. Press
Locate/OK
[5] to save.
E. Selecting External Jack [14] ([13] on 2250M) Frequencies (Tone
Frequencies)
MENU [6] + >>More [SK:4] + Setup [SK:6] + >>More [SK:6d] + Tone Freq [SK:6j]
A coupler can be plugged into the
External Jack
[14] ([13]) on 2250M) of the receiver and used to
identify cables. (See
Additional Applications: Cable
Identification, Section 19B.
) The same procedure
as
D. Enabling/Disabling Frequencies
(above)
is followed for selecting frequencies that can be
detected by the
External Jack
[14] ([13]) on 2250M)
found on the bottom of the receiver.
F. Creating User Defined Frequencies
MENU [6] + >>More [SK:4] + Setup [SK:6] + >>More [SK:6d] + Locate Freq [SK:6g]
There are four user defined frequencies available on the receiver. (These frequencies
must be between 50 Hz and 999 Hz.) These frequencies are found in the column on the
far right of the Locate Freq display (Auxiliary frequencies). These frequencies, once
programmed, will appear in the Locate mode under the
Aux
[SK] frequency list when
Freq
[SK] is selected in the Locate mode.
Summary of Contents for Dynatel 2250M
Page 64: ...64 78 8130 6150 0 F ...
