Bair Paws Model 875 Warming Unit Service Manual
20
Check the 3M
TM
Bair Paws
TM
system website to ensure you have the most recent version of this document.
www.bairpaws.com reorder #202036A
7� To replace the hose or controller remove the two screws that connect the wire collar to
the mid-hose coupler and pull the wire out through the dedicated hole (see Figure 14)�
Note: If you are replacing both the hose and controller do not remove the wire collar
from the hose� Proceed to Step 8�
8� Using either a replacement temperature controller assembly and/or a replacement hose,
thread the controller wire through the dedicated hole� Hold the hose vertical and let the
wire plug drop through to the end-of-hose coupler�
9� Secure the wire collar to the mid-hose coupler with two screws�
10� If replacing the hose, transfer the case bottom onto the new hose�
11� Plug the controller wire into the port on the control board�
12� Making sure that the controller wire passes through the clearance slot, insert the end-of-
hose coupler into the warming unit (see Figure 15)�
Note: Ensure the end-of-hose coupler ridge is seated under the control board�
13� Replace the cover�
14� Install the three screws on the back of the unit�
15� Reposition the case bottom with the filter and attach to the warming unit with two screws�
16� Plug the unit into a proper power source�
17� Calibrate unit and test OT circuit�
Mid-hose
coupler
Wire collar
Figure 14� Removing the existing controller wire from the hose�
Figure 15� Inserting the end-of-hose coupler into the warming unit�
Clearance
slot
Controller
wire
Ridge of end-of-hose coupler
End-of-hose
coupler