3e–525C–3 Wireless Access Point
Chapter 5: Wireless Bridge Configuration
29000171-001 A
71
Chapter 5: Wireless Bridge Configuration
Introduction
In the 3e–525C–3, wireless bridging uses a second WLAN card to set
up an independent wireless bridge connection. Since wireless bridging
provides a mechanism for APs to collaborate, it is possible to extend the
basic service set (BSS) of a standalone AP and to connect two separate
LANs without installing any cabling.
The wireless bridging function in the 3e–525C–3 supports a number of
bridging configurations. Some of the most popular settings are discussed
in this chapter:
•
Point-to-point bridging of two Ethernet links
•
Point-to-multipoint bridging of several Ethernet links
•
Repeater mode
The wireless bridging screens are the same whether you are in access
point or gateway mode.
Bridging is a function that is set up in addition to basic access point
or gateway setup. If you will be using the 3e–525C–3 solely as a bridge,
some of the settings you may have selected for access point/gateway use
will not be necessary.
If setting up as a bridge during initial setup, you can either use the
LAN Port directly wired by Ethernet cable to a laptop to set the appro-
priate settings. The management screens that you may need to modify,
regardless of what type of bridging mode you choose, will be in the
Wire-
less Bridge
section of the navigation bar. These include:
• Wireless Bridge — General
• Wireless Bridge — Radio
• Wireless Bridge — Encryption
