2
GETTING STARTED
Figure 2.36: Position of nozzle tip after HBP leveling
Note:
1. Do not be confused with the 3-point thumb screws in the middle of Y-axis mount
plate and the bed tightening screws in the four corners of HBP. (Figure 2.37)
Figure 2.37: HBP thumb screws
2. When adjusting the 3-point thumb screws, you may feel it is very tight to turn
the screws. This is normal. The Artifex 3D Printer uses quite strong wave springs
for bed leveling to prevent the screw to get loose during printing.
2.2.3
Loading filaments
Step 1 Feeding filament through the filament guide tube
Free the end of filament from the filament spool, and cut off the bent section used to
secure the filament to the spool. Feed the filament into the rear end of filament guide
http: // 3dmakerworld. com
39
