3Dlabs Wildcat 4210, User Manual

Page: 15 / 34

9
To connect VGA monitors to a Wildcat 4210 VIO video card:
1. Make sure power to the computer and to the monitors is turned off.
2. If you are connecting a single monitor, connect the VGA connector on the monitor cable to the
analog video output port marked 1st (see Figure 6). If needed, connect the VGA connector on the
monitor cable for a second monitor to the analog video output port marked 2nd.
3. Turn on power to the computer and to the monitors. If the monitors’ Power On LEDs do not
illuminate or the monitors do not display, refer to Chapter 4, “Troubleshooting.”
Figure 6. Analog Video Out Ports (Wildcat 4210 VIO Only)
Installing the Driver Software
Refer to the operating system documentation and online Help for more information on installing driver
software.
Make sure the computer has the following before installing the Wildcat 4210 driver:
♦
Microsoft Windows 2000 or Windows NT Workstation 4.0 with Service Pack 5 (or later)
♦
3 MB of free space on the computer’s primary system disk
CAUTION You must have the correct driver for Windows 2000 or Windows NT 4.0. If you are
unsure, refer to the
README
file on the driver CD or diskette for this information.
If you are reinstalling the Wildcat 4210 driver, you must first remove the currently installed Wildcat
driver.
To remove the existing Wildcat driver in Windows 2000:
1. Log on to Windows 2000 using an account that has administrative privileges.
2. Go to Start » Settings » Control Panel » Add/Remove Programs » Change and Remove Programs.
3. Highlight the Wildcat Display Driver and click Change/Remove.
Analog Video Out
Analog Video Out