3D Prototyping X1, User Manual

Page: 56 / 58

3D Prototyping X1
54
figure7.4.4
5. Click “ ”from “platform Leveling” dialog box, and move the worktable to the
corner (“bottom left” corner) which corresponding screw “
（
（ （
（
a
）
） ）
）
”
6. Click “ ”from “platform Leveling” dialog box to rise the worktable to highest
point. If worktable is too near nozzle, please adjust a little from “Control Panel”. If the
worktable is too far from nozzle, don’t need to adjust, you can set the Z axis height after
the worktable leveling.
7. Click “ ”from “platform Leveling” dialog box and move the worktable to the
corner (“bottom right ”corner) which corresponding screw “(b)” . Then compare the height
of “bottom left” corner (the height between nozzle and worktable, similarly hereinafter) ,
and adjust screw “(b)” to make sure the height is the same as “ bottom left corner”. Click
“ ” and “ ” to check the height difference and adjust to the same
height as nozzle. After finishing, don’t move this two screws any more.
8. Click “ ”from “platform Leveling” dialog box and move the worktable to the
“center of Y axis” position and check the height to adjust screw “(c)” to make sure the
height is the same as we did in last step. Click “ ” and “ ” to check