3D Prototyping X1, User Manual

Page: 46 / 58

3D Prototyping X1
44
Strip rate reflects the height between model and raft. If the layer thickness is 0.2mm, while
the strip rate is 2, then the height between model and raft is 0.4mm
When the slope angle is larger than this value, support will be generated, in general, the
larger the angle, the less support.
The model has a slope of 45 degrees, if you do not want to generate support for this point
of view of the support, it should be set more than 45; if you want to have support, set this
parameter as less than 45.
Reset to default when you want to recover the factroy default value.