![background image](http://html.mh-extra.com/html/3d-printing-systems/up-plus-2/up-plus-2_user-manual_441976022.webp)
UP Plus 2 3D Printer User Manual v 2013.10.24
Loosen a screw and the related corner of platform will rise. Tighten, or loosen, the screws until
you have the same gap between the nozzle and the platform at all four corners of platform.
7. Platform height (Automatic & Manual)
There are two ways of setting the platform height Automatic and Manual. The easiest method is to
use the Automatic method.
7.1
Automatic Platform Height Setup
1.
Plug in the black calibration cable into the back of the
platform height sensor and the other end into the cali-
bration port on the back of the printer.
2.
In the software, click 3D Print / Nozzle Height Detect.
(if “Nozzle Height Detect” is greyed out check the
connections)
3.
The table will rise up and the nozzle will touch the sil-
ver switch in order to automatically set the height.
(the value will be /- 135mm)
7.2 Manual Platform Height Setup
If using the automatic method, you don’t need to do the manual setup.
Please read this care-
Summary of Contents for UP Plus 2
Page 1: ...UP Plus 2 3D Printer User Manual v 2013 10 24 ...
Page 8: ...UP Plus 2 3D Printer User Manual v 2013 10 24 2 1 Appearance Figure 1 Front view of printer ...
Page 10: ...UP Plus 2 3D Printer User Manual v 2013 10 24 2 3 Accessories PARTS ...
Page 56: ...UP Plus 2 3D Printer User Manual v 2013 10 24 ...