3D Corporation ProJet 5000, Manual

Page: 20 / 94

1.
2.
3.
4.
5.
6.
The printer has up to four material delivery modules for part materials and up to four material delivery modules for support materials. The support
delivery modules are located on the left side and the part delivery modules are located on the right side of the printer. Each delivery module holds
one (1) bottle of material.
NOTE: Before handling the part material bottle, read the Material Safety Data Sheet (MSDS .
Unpack bottles and the MSDS/SDS Sheet from cartons.
Open left and/or right material delivery doors. Pull material
delivery module (MDM) handle down and out to open.
Install bottle into the MDM; press bottle down until a click
sounds.
To ensure that bottle is locked in place, gently pull on bottle. If
bottle is loose, press bottle down to ensure it is secured in MDM.
Loosen bottle cap 1/2 to 3/4 turn counterclockwise to allow the
bottle to vent.
Before removing bottle from the MDM, re-tighten bottle cap to
prevent spillage. To remove bottle, open material delivery
module and press release latch down and lift bottle out of
module.
Build Platform