arp
311
arp
The
arp
Global Configuration mode command adds a permanent entry in
the Address Resolution Protocol (ARP) cache. To remove an entry from the
ARP cache, use the
no
form of this command.
Syntax
arp
ip_addr hw_addr
{
ethernet
interface-number
|
vlan
vlan-id
|
port-channel
port-channel number
.}
no arp
ip_addr {
ethernet
interface-number
|
vlan
vlan-id
|
port-channel
port-channel number.
}
Parameters
■
ip_addr
— Valid IP address or IP alias to map to the specified MAC
address.
■
hw_addr
— Valid MAC address to map to the specified IP address or IP
alias.
■
interface-number
— Valid Ethernet port.
■
vlan-id
— Valid VLAN number.
■
port-channel number
. — Valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuratin mode
User Guidelines
The software uses ARP cache entries to translate 32-bit IP addresses into
48-bit hardware addresses. Because most hosts support dynamic
resolution, static ARP cache entries do not generally have to be specified.
IP address
I/F
Type
Direct
Broadcast
-------------
---------
--------------
--
10.7.1.192/24
1
Static
disable
10.7.2.192/24
2
Static
disable
Summary of Contents for 3CRUS2475 24
