4
. SETU
P
E-Mail Notify
•
The system can make an email notification to the IP address of
Remote Manager PC over the network.
•
User can choose various different kinds of alarms by pressing “ADD”
for such as Log-in/Out, System start, Sensor, Video loss, Recording
failure, Setup, Shutdown, Motion alarm, S.M.A.R.T., and HDD full.
•
The maximum number of email recipient is 8.
83
NOTE
User can set remote pop-up in RemoteManager S/W(RMS) upon
alarm trigger in DVR.
In order for RMS user to receive an instant pop-up video over
network from DVR, DVR user has to tick “SENSOR” or “MOTION
ALARM” in above menu.
“SENSOR” means the alarm triggered by physical alarm, while
“MOTION ALARM” means the alarm triggered by motion detection.
NOTE
Configuration first priority is always on “SCHEDULE” of “RECORD”.
Thus, the system will not email alarm message upon motion alarm
or sensor even though user ticks the check-box of above event
selection, unless user sets the “SCHEDULE” of “RECORD” and
“MOTION”/”SENSOR” of “DEVICE” accordingly.
For example, If user sets just “Continuous” only in “SCHEUDLE” of
“RECORD” and tick “All” check-box of “REMOTE NOTIFY”, then the
system will not make email notification. In this case, user has to
set “CONT + MOT”, “MOTION”, “SENSOR”, or “CON + SENS” and then
tick “ALL” check –box in order to enable Email Notification
properly.
4.5 NETWORK
Summary of Contents for T Series
