![background image](http://html.mh-extra.com/html/360-vision/t-series/t-series_user-manual_440267082.webp)
Remote Notify
•
The system can notify an alarm message to the IP address of Remote
Manager PC over the network.
•
User can choose various different kinds of alarms by pressing “ADD”
for such as Log-in/Out, System start, Sensor, Video loss, Recording
failure, Setup, Shutdown, Motion alarm, S.M.A.R.T., and HDD full.
•
The maximum number of message recipient is 8.
4
. SETU
P
82
NOTE
Configuration first priority is always on “SCHEDULE” of “RECORD”.
Thus, the system will not notify alarm message upon motion alarm
or sensor even though user ticks the check-box of above event
selection, unless user sets the “SCHEDULE” of “RECORD” and
“MOTION”/”SENSOR” of “DEVICE” accordingly.
For example, If user sets just “Continuous” only in “SCHEUDLE” of
“RECORD” and tick “All” check-box of “REMOTE NOTIFY”, then the
system will not notify alarm message. In this case, user has to set
“CONT + MOT”, “MOTION”, “SENSOR”, or “CON + SENS” and then
tick “ALL” check –box in order to enable REMOTE NOTIFY properly.
4.5 NETWORK
4.5.3 NOTIFICATION
Summary of Contents for T Series
