2N TELEKOMUNIKACE a.s., www.2n.cz
65/143
Bank holiday list
A list of dates to which the weekend routing mode should be applied in the LCR table.
DTMF settings
The minimum delay between two identical DTMF characters received [s/100].
Tone detector settings
The GSM gateway can automatically detect user defined tones sent by the GSM/UMTS
network during call setup. In general, user defined tones are tones of the number to be
transmitted. Having detected such tone, the GSM gateway terminates the call
automatically and attempts to set it up through the next available outgoing group (as
defined in the LCR table).
Frequency 1;2;3;4 – defined frequency of the tone to be detected.
Sequence list – sequence of the above defined tones for detection.
Voice message detector settings
Minimum percent to match – set the match percentage range in which the voice
message is detected as identical with one of the voice messages recorded in the
section under index 30–37. The recommended
Gateway control/Voice messages
value is 70–90%.
Cinterion Module Settings
Transmission volume [dB] – set the module volume for the outgoing direction.
Reception volume [dB] – set the module volume for the incoming direction
Enable connection tone – enable the connection tone.
End call with SHUP – end calls with the SHUP command.
Enable HR codec – enable the Half Rate codec for the GSM network.
Enable AMR codec – enable the Adaptive Multi-Rate codec for the GSM network.
Wavecom Module Settings
Transmission volume [dB] – set the module volume for the outgoing direction.
Reception volume [dB] – set the module volume for the incoming direction
GSM-band selection – select the GSM frequencies for the mobile network.
Echo cancelling – enable/disable echo cancelling for the module.
Enable HR codec – enable the Half Rate codec for the GSM network.
Enable AMR codec – enable the Adaptive Multi-Rate codec for the GSM network.
Telit Module Settings
