2N LiftNet, User Manual

Page: 64 / 99

Parameter Chart (FW v. 1.9.1) 3.2
64
Par.
No.
Parameter Name Range Default Note
the Service Tool).
986
Days in week for
checking calls
mtwtfss blank
mtwtfss values
0 = do not call
1 = call
M = Monday
T = Tuesday
W = Wednesday
…
S = Sunday
990 System setting 0 - 1 0
0=active and rest bus statuses (for longer
battery back-up in the event of power outage),
1 = active bus status only (higher Emi For long
buses for noisy environment)
991 Service password
up to 16
digits 0 - 9
12345
996 Fireman settings XY blank
Format XY
X = shaft value as set in the Fire Station cabin
audio unit (1-8)
Y = define whether activation is made by a
button (0, first press = activate, second press =
deactivate), or using a key (1)
997 Firmware version
Identifies the firmware version, reading *
instead of dots.
998
Automatic upgrade of
audio units
0 - 1 1
If set to 1, the CU will automatically upgrade all
connected audio units while booting up.
999
Full initialisation
(including service
password!)
Re-enter the valid service password as the
function parameter (as protection against
unintended deletion if you enter a false function
number).
PC Configuration
For this purpose, install the 2N
®
LiftManager software on your PC. It consists of two
parts:
1. Dispatching centre software. Allows for automatic receipt of checking calls and
other dispatching functions. Requires a modem. Is limited to a few lifts only
without licence.
2. Service tools. This part is fully functional without licences. Helps configure the
LN, which is connected to the PC through a USB interface. Also enables to
upgrade the firmware. At present, no remote PC configuration or upgrade are
possible.
For more information, install and run 2N
®
LiftManager from the CD enclosed.