2N IP Vario, Installation Manual, Page: 72 / 106

2N TELEKOMUNIKACE a.s., www.2n.cz 72/106
Status signalling:
Green LED Red LED Status
blinking off Operational mode
on off Activated output
blinking blinking Programming mode – waiting for initialisation
on blinking Error – wrong code received
Configuration:
Connect the to the properly set intercom switch output; 2N Security Relay
®
refer to the . Make sure that one LED at Configuration manual for 2N IP intercoms
least on the is on or blinking. 2N Security Relay
®
Press and hold the Reset button for 5 seconds to put the 2N Security Relay
®
device in the programming mode (both the red and green LEDs are blinking).
Activate the intercom switch using the keypad, telephone, etc. The first code
sent from the intercom will be stored in the memory and considered valid. After
code initialisation, the will pass into the operational mode 2N IP Security Relay
®
(the green LED is blinking).
Caution
In case of resetting the factory default settings on a device with a
version of firmware 2.18 or higher it is necessary to reprogram the
using the instructions above. 2N Security Relay
®