B. Assembly and Installation
Model AQSync Air Quality Monitoring Station Manual Rev. A-1
6
B. Assembly and Installation of the AQSync
B.1
Assembly
The weather station and particulate matter (PM) sampling inlet are detached from the
AQSync for shipping, to protect them from damage. Carefully unpack them and install
them as shown here.
B.1.1
Install PM Sampling Inlet
Obtain the pieces of the Particulate Matter Sampling Inlet as shown below. After
following these steps, the PM Inlet will be installed as shown in the picture at the right.
The AQSync has an aluminum flange on the top, as shown at
right. The PM Inlet is installed into this flange.
Final Install
Core Shield Assembly
Nut
Washer
Rubber
Gasket
Inlet Cover
Heat
tape