37
1. Keep the treadmill in no-load running and adjust speed to 6KM/H.
2. Observe the distance from running belt to left and right edgestrips.
•
If the running belt tilts towards the left, turn the left screw by 1/4 of a circle clockwise
with Allen wrench.
• If the running belt tilts towards the right, turn the right screw by 1/4 of a circle clockwise
with Allen wrench.
• If the running belt is still not in the middle, repeat the above steps until it is in the
middle.
3. Adjust speed to 16KM/H after adjusting running belt to the middle, and observe
deviation of running belt and smoothness of running. Repeat steps of adjustment in case
of deviation.
4. Warning! Please don’t tighten the roller excessively! This will cause permanent damage to
the bearing!
You need to tighten the running belt again if the above steps fail to reach the effect.
Lubricating oil (MANUAL OIL)
The treadmill is oiled when leaving the factory, but lubricity of treadmill shall be inspected
frequently, which helps to keep it in optimum state. The treadmill must be oiled after 1 year or
running for 100h.
Lift one side of the running belt and touch the surface of running platform after running for 30h or
30 days. It is unnecessary to lubricate if there is silicone oil; if the surface is clearly dry, please oil
it as instructed below.
As shown in the figure, it needs to open the
oil cap, pour the silicon oil into the oil port, after
finished,turn on the treadmill to run for some time.
Adjust running belt to back of treadmill on both sides.
Summary of Contents for 190T
Page 46: ...44 ...
