Chapter 21 Classifier
XGS1930 Series User’s Guide
183
21.3.1 Viewing and Editing Classifier Configuration Summary
To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the
Classifier
screen. To change the settings of a rule, click a number in the
Index
field.
Note: When two rules conflict with each other, a higher layer rule has priority over lower layer
rule.
Figure 135
Advanced Application > Classifier > Classifier Configuration: Summary Table
The following table describes the labels in this screen.
Socket
Number
Note: You must select either
UDP
or
TCP
in the
IP Protocol
field before you configure the
socket numbers.
Select
Any
to apply the rule to all TCP/UDP protocol port numbers or select the second option and
enter a TCP/UDP protocol port number.
Add
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is turned
off or loses power, so use the
Save
link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel
Click
Cancel
to reset the fields back to your previous configuration.
Clear
Click
Clear
to set the above fields back to the factory defaults.
Table 81 Advanced Application > Classifier > Classifier Configuration (continued)
LABEL
DESCRIPTION
Table 82 Advanced Application > Classifier > Classifier Configuration: Summary Table
LABEL
DESCRIPTION
Index
This field displays the index number of the rule. Click an index number to edit the rule.
Active
This field displays
Yes
when the rule is activated and
No
when it is deactivated.
Weight
The field displays the priority of the rule when the match order is in
manual
mode. A higher weight
means a higher priority.
Name
This field displays the descriptive name for this rule. This is for identification purpose only.
Rule
This field displays a summary of the classifier rule’s settings.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the table
heading row to select all entries.
Delete
Click
Delete
to remove the selected entry from the summary table.
Cancel
Click
Cancel
to clear the check boxes.
Содержание XGS1930-28HP
