ZyXEL Communications WSQ60, Руководство пользователя

Страница: 129 / 210

Multy WiFi System User’s Guide
129
6.6 Bridge Mode Overview
Use your Multy M1 as a bridge if you already have a router or gateway on your network. In this mode
your Multy M1 bridges a wired network (LAN) and wireless LAN (WLAN) in the same subnet. See the
figure below for an example.
Many screens that are available in Standard Mode are not available in Bridge Mode , such as port
forwarding and firewall. See Section 5.3 on page 122 for more information.
6.7 What You Can Do
• Set up a network with the Multy M1 as a bridge ( Section 6.8 on page 129 ).
• Use the Status screen to view read-only information about your Multy M1 ( Section 6.9 on page 131 ).
6.8 Setting your Multy M1 to Bridge Mode
1
Log into the Web Configurator if you haven’t already. See the Quick start Guide for instructions on how
to do this.
2
To use your Multy M1 as a bridge, go to Settings > System > Operating Mode and select Bridge Mode .
Note: You can only set the Multy M1 to Bridge Mode when using the Internet Protocol over
Ethernet (IPoE) WAN service.
IP Subnet Mask This shows the WAN port’s subnet mask.
Gateway This shows the WAN port’s gateway IP address.
IPv6 Address This shows the current IPv6 address of the Multy M1.
LAN Information
MAC Address This shows the LAN Ethernet adapter MAC Address of your device.
IP Address This shows the LAN port’s IP address.
IP Subnet Mask This shows the LAN port’s subnet mask.
DHCP Server This shows the LAN port’s DHCP role - Enable or Disable .
IPv6 Address This shows the current IPv6 address of the Multy M1 in the LAN.
Table 10 Settings > System > Status (Standard Mode) (continued)
LABEL DESCRIPTION