ZyXEL Communications SBG5500-A, Руководство пользователя

Страница: 118 / 274

Chapter 7 Routing
SBG5500 Series User’s Guide
118
7.4 The Static Route Screen
Use this screen to view and configure the static route rules on the SBG. Click Configuration > Routing >
Static Route to open the following screen.
Figure 91 Configuration > Routing > Static Route
Address Select Any if the policy route packets will go to all IP addresses. Otherwise select IP Address to
specify the destination IP address, or select Subnet to specify the destination subnet mask.
IP Address Enter a source IP address object to which the packets go.
Subnet Mask Enter a subnet mask address object to which the packets go.
MAC
Address
Enter a MAC address object to which the packets go.
Destination
Port
Enter the port number (1-65535) to which the packets go. The SBG applies the policy route to the
packets that go to the corresponding service port.
Any means all service ports.
Protocol Select TCP or UDP if you want to specify a protocol for the policy route. Otherwise select None .
Next-Hop
WAN Interface Select the WAN interface to route the matched packets through the specified outgoing
interface to a gateway (which is connected to the interface).
Advanced
Disable this
policy rule
automatically
while the
selected next-
hop is
unreachable Select this if you want the SBG to disable a policy rule if next-hop is unreachable.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 38 Policy Route: Add/Edit (Sheet 2 of 2)
LABEL DESCRIPTION