Chapter 7 Routing
SBG5500 Series User’s Guide
117
Figure 90
Policy Route: Add/Edit
The following table describes the labels in this screen.
Table 38 Policy Route: Add/Edit (Sheet 1 of 2)
LABEL
DESCRIPTION
Configuration
Enable
Select this to activate the policy route.
Policy Name
Enter a descriptive name for the policy. It should begin with a letter and cannot exceed 31
characters [0-9][A-Z] [a-z][_-].
Order
Select an existing number for where you want to put this policy route to move the policy route to
the number you selected after clicking
OK
. Ordering your rules is important because the SBG
applies the rules in the order that you specify.
Criteria
Source
Use this section to configure where the packets are coming from in this policy route.
Address
Select
Any
if the policy route will receive packets from all IP addresses. Select
IP Address
to
specify the source IP address. Otherwise, select
Subnet
to specify the source subnet mask.
IP Address
Enter a source IP address object from which the packets are sent.
Subnet Mask Enter a subnet mask address object from which the packets are sent.
MAC
Address
Enter a MAC address object from which the packets are sent.
Source Port
Enter the port number (1-65535) from which the packets are sent. The SBG applies the policy
route to the packets sent from the corresponding service port.
Any
means all service ports.
Destination
Use this section to configure where the packets are going from in this policy route.
Содержание SBG5500-A
Страница 12: ...12 PART I User s Guide...
Страница 44: ...44 PART II Technical Reference...
Страница 58: ...Chapter 5 WAN Internet SBG5500 Series User s Guide 58 Figure 49 WAN Internet WAN Setup Add Edit Routing Mode...
Страница 69: ...Chapter 5 WAN Internet SBG5500 Series User s Guide 69 Figure 53 Configuration WAN Internet Mobile...
