Prestige 681 SDSL Router
Bridging Setup
8-3
8.2.1 Remote Node Bridging Setup
Follow the procedure in
Chapter 5:
to configure the protocol-independent parameters in
Menu 11.1 -
Remote Node Profile
. For bridging-specific parameters, you need to configure
Menu 11.3 - Remote Node
Network Layer Options
.
To set up
Menu 11.3 - Remote Node Network Layer Options
follow these steps:
Step 1.
In Menu 11.1, make sure the
Bridge
field is set to
Yes
.
Step 2.
Move the cursor to the
Edit IP/IPX/Bridge
field, then press the [SPACE BAR] to toggle this
field to
Yes
and press [
ENTER]
to open
Menu 11.3 - Network Layer Options
.
Figure 8-2
Menu 11.3 - Remote Node Bridging Options
The following table describes the bridging-specific parameters in
Menu 11.1 - Remote Node Profile
and
Menu 11.3 - Remote Node Network Layer Options
.
Table 8-2
P681 Remote Node Network Layer Menu Bridge Options
Field
Description
Bridge (menu 11.1)
Make sure this field is set to
Yes
.
Edit IP/IPX/Bridge
(menu 11.1)
Press the [SPACE BAR] to change the default to
Yes
and then press
[ENTER] to go to
Menu 11.3 - Network Layer Options
.
Ethernet Addr
Timeout (min) (menu
11.3)
In this field, enter the time (number of minutes) that you wish your
Prestige 681 to retain the Ethernet Addr information in its internal tables
while the line is down. If this information is retained, your Prestige 681
will not have to recompile the tables when the line is brought back up.
Menu 11.3 - Remote Node Network Layer Options
Frame Relay Parameters :
DLCI= 16
IP Options :
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Single User Account= No
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
IPX Options :
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
Bridge Options:
Ethernet Addr Timeout(min)= 0
Enter here to CONFIRM or ESC to CANCEL:
