ZyXEL Communications P-873HNU-51B, Руководство пользователя

Страница: 144 / 339

Chapter 10 Quality of Service (QoS)
P-873HNU(P)-51B User’s Guide
144
10.6 The QoS Policer Setup Screen
Use this screen to configure QoS policers that allow you to limit the transmission rate of incoming
traffic. Click Network Settings > QoS > Policer Setup. The screen appears as shown.
Figure 56
Network Settings > QoS > Policer Setup
The following table describes the labels in this screen.
VLAN ID If you select Remark, enter a VLAN ID number with which the VDSL Router
replaces the VLAN ID of the frames.
If you select Remove, the VDSL Router deletes the VLAN ID of the frames
before forwarding them out.
If you select Add, the VDSL Router treat all matched traffic untagged and add
a second VLAN ID.
If you select Unchange, the VDSL Router keep the VLAN ID in the packets.
To Queue Index Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 37
Class Setup: Add/Edit (continued)
LABEL DESCRIPTION
Table 38
Network Settings > QoS > Policer Setup
LABEL DESCRIPTION
Add new Policer Click this to create a new entry.
# This is the index number of the entry.
Status This field displays whether the policer is active or not. A yellow bulb signifies
that this policer is active. A gray bulb signifies that this policer is not active.
Name This field displays the descriptive name of this policer.
Regulated Classes This field displays the name of a QoS classifier
Meter Type This field displays the type of QoS metering algorithm used in this policer.
Rule These are the rates and burst sizes against which the policer checks the traffic
of the member QoS classes.