Chapter 6 Advanced Application Configurations
MGS3750-28F User’s Guide
35
Figure 25
EAPS Screen
The following table describes the fields in this screen.
Table 18
EAPS Screen
LABEL
DESCRIPTION
Active
Select this option to enable EAPS.
Hello Time
This is the time interval in seconds between BPDU (Bridge Protocol Data Units)
configuration message generations by the root switch. The allowed range is 1 to 10
seconds.
Fail Timer
Type a figure to define a time during which the hello packet should be received. If the
master node secondary port fails to receive the hello packet, and the Switch will
consider that a link fault has occurred on the ring network.
Major Fault
Type a figure to define a time during which a report needs to be made by the
assistant-edge node. Otherwise, the primary ring in the domain will be considered
faulty.
Pre Forward
Type a figure to define a time that the transit node will stay in the Pre-forwarding state
with the port recovered blocked if the temporary loop occurs.
Pre Up
Type a figure to configure recovery timer value.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Domain ID
Select a domain configuration mode.
Control VLAN
The Control VLAN range is from 2-4094. The destination VLAN in the ERPS protocol
packet must be a VLAN that does not exist on the system.
Work Mode
Select
standard
,
EIPS
, or
RRPP
Mode.
Topo Collect
Click the check box to enable topology discovery.
Add
Click
Add
to insert the entry in the summary table below and save your changes to
the Switch’s run-time memory. The Switch loses these changes if it is turned off or
loses power.
Cancel
Click
Cancel
to reset the fields back to your previous configuration.
Clear
Click
Clear
to delete the configurations of the above fields.
