ZyXEL Communications MGS3520 Series, Руководство пользователя

Страница: 357 / 431

Chapter 42 Access Control
MGS3520 Series User’s Guide
357
42.3.5 Configuring SNMP Trap Group
Click Management > Access Control > SNMP > Trap Group to view the screen as shown. Use
the Trap Group screen to specify the types of SNMP traps that should be sent to each SNMP
manager.
Figure 227
Management > Access Control > SNMP > Trap Group
The following table describes the labels in this screen.
Version Specify the version of the SNMP trap messages.
IP Enter the IP addresses of up to four managers to send your SNMP traps to.
Port Enter the port number upon which the manager listens for SNMP traps.
Username Enter the username to be sent to the SNMP manager along with the SNMP v3 trap.
Note: This username must match an existing account on the Switch (configured in the
Management > Access Control > SNMP > User
screen).
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 178
Management > Access Control > SNMP (continued)
LABEL DESCRIPTION
Table 179
Management > Access Control > SNMP > Trap Group
LABEL DESCRIPTION
Trap Destination
IP Select one of your configured trap destination IP addresses. These are the IP addresses of
the SNMP managers. You must first configure a trap destination IP address in the
SNMP
Setting screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Type Select the categories of SNMP traps that the Switch is to send to the SNMP manager.