ZyXEL Communications MGS3520 Series, Руководство пользователя

Страница: 316 / 431

Chapter 37 Static Route
MGS3520 Series User’s Guide
316
Metric The metric represents the “cost” of transmission for routing purposes. IP routing uses hop
count as the measurement of cost, with a minimum of 1 for directly connected networks.
Enter a number that approximates the cost for this link. The number need not be precise,
but it must be between 1 and 15. In practice, 2 or 3 is usually a good number.
Add Click Add to insert a new static route to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the above fields to your previous configuration.
Clear Click Clear to set the above fields back to the factory defaults.
Index This field displays the index number of the route. Click a number to edit the static route
entry.
Active This field displays Yes when the static route is activated and No when it is deactivated.
Name This field displays the descriptive name for this route. This is for identification purposes
only.
Destination
Address This field displays the IP network address of the final destination.
Subnet Mask This field displays the subnet mask for this destination.
Gateway
Address This field displays the IP address of the gateway. The gateway is an immediate neighbor of
your Switch that will forward the packet to the destination.
Metric This field displays the cost of transmission for routing purposes.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the Delete check boxes.
Table 151
IP Application > Static Routing > IPv4 Static Route (continued)
LABEL DESCRIPTION