Zycoo CooFone-D30, Руководство пользователя

Страница: 61 / 79

Copyright ©ZYCOO All rights reserved. V1.0
57
Use the multicast function to send notice to every member of the multicast is simple and easy. By setting the
multicast key on your phone, you can send multicast RTP flow to the pre-configured multicast address. By listening
multicast address is configured on the phone, listen and play the multicast address to send the RTP stream.
Send multicast setting
On the phone web page, function key-function key, set a function key as shown below.
Value format IP: Port, the IP address of multicast is range from 224.0.0.0 to 239.255.255.255, port is greater than
1024
If multicast codec is G722, the LCD screen will displays "HD", which means the phone is sending high-definition voice
stream
Operate steps:
2
、
When the phone is idle, press multicast key
Multicast RTP stream is sent to pre-configured multicast address (IP: Port).The phone which listens to multicast
address in the local network can receive the RTP stream. Multicast function key LED lights yellow.
LCD screen displays the following:
4
、
Press the hold key to hold the current multicast session
5
、
Press the end key again or multicast function key, multicast session can be stopped
Notice: RTP stream is one side that is from a sender to a receiver. When the phone initiates a multicast RTP session
in a call, the current call is on hold.
Receive multicast setting
You can set up the phone monitoring 10 different multicast addresses to receive these multicast RTP stream.
You have two methods to receive RTP stream of multicast that can be set up through the web page:
Enable priorities of normal calls and Enable page Priority:
Enable priorities of normal call by select it, if the incoming RTP stream priority of multicast lower than the priority
to current for normal calls, the phone will ignore the RTP stream of multicast. If the incoming RTP stream priority
to multicast higher than the priority of current for normal calls, the phone will receive the RTP stream of multicast,
and hold the current call.
Disabled priorities of normal call by select disable, the phone will ignore all local networks RTP stream of multicast.
Options as follows:
1-10: the priority defined for normal calls, 1 the highest level, 10 the lowest level
Disabled: Ignore all RTP stream of multicast