FV741 Rev. A 01/20/21
Page 4
FV741 Rev. A 01/20/21
Page 3
4. Assemble the electronics module
Do not connect the electronic module to spout
Cable to
monitor
1. Install Monitor on wall surface within 2 feet radius of faucet
with dry wall anchors & screws or doubled sided VHB tape
2. Loosen lid screw with supplied 3mm Allen wrench. Open lid
and install supplied batteries. Close lid and tighten lid screw.
5. Tighten electronics module assembly to shank and connect
water line(s).
3.
Connect monitor and electronics module assembly.
Do not connect cable to the spout at this step.
4. Open battery module using supplied 3mm Allen wrench and
install supplied batteries in the electronics module. Then close
and tighten battery module..
Use AA Lithium Batteries or AA Alkaline batteries, but do not mix Lithium
with Alkaline.
Use AA Lithium Batteries or AA Alkaline batteries, but do not mix Lithium
with Alkaline.
Monitor & Electronic Module Installation Instructions
2. Install spout to sink using spout base gasket, plastic mounting
washer, star washer and mounting nut.
Note: Faucet location needs to be within 3 feet radius above
electrical outlet for ACA configurations.
NOTE
: Before installation, turn off water supplies to existing faucet and remove faucet if replacing an existing device.
Clean the faucet basin and clear away debris. Flush all supply lines before connecting the faucet. Failure to do so
may result in debris clogging the inlets and/or internal control and mixing valve
1. Carefully screw aerator into spout using included tool.
Take care to not pinch blue o-ring
3. Ensure that slot in plastic washer is facing forward.
Sensor cable should not pass through plastic mounting washer.
Spout Installation Instructions
Z6913-XL-W2
Z6915-XL-W2
Cover Plate Installation Instructions
1. (For faucets with -CP4 or -CP8 suffix).
Remove adhesive backing from gasket and then pass sensor
connector wire and shank through gasket. Align gasket with
faucet bottom and press firmly together. Pass sensor connector
and shank through cover plate and fasten to the faucet with the
provided screws.
