ZURN Aquaflush Z6000, Инструкция по установке, эксплуатации, обслуживанию и каталог запасных частей

Страница: 29 / 89

AquaSense Batter
y
P
owered Flush
V
alves/Retrofit Kits
Using supplied battery compartment wrench,
remove battery compartment from the
E-Z Flush
™
unit.
Load batteries into compartment tray (note position of batteries in tray), and
reinstall battery tray into the E-Z Flush unit.
Secure tray with battery compartment wrench. The last three turns of the
wrench will activate the E-Z Flush unit. The E-Z Flush System is now
operational.
Your E-Z Flush unit comes preset from the factory. If special circumstances
require adjustment of the activation distance, see Step 7 – “To Change Sensor
Activation Distance.”
The E-Z Flush unit has a 10-minute start-up sequence in which the sensor
will flash the User-In-View
yellow L.E.D. continuously as long as a user is in
view. After the start-up sequence is completed and when the sensor has a
user in view, the User-In-View
yellow L.E.D. will flash only 3 times after a
5-second delay. This delay prevents needless flushes when someone walks by.
ACTIVATION
Remove Battery Compartment
Install Battery Compartment
4
5
VISUAL INDICATOR GUIDE
USER-IN-VIEW L.E.D. Yellow light flashes 3 times –
after 5-second delay – when a user is in view. The
yellow light flashes constantly when a user is in view
during the 10-minute start-up sequence.
SENSOR
BATTERY L.E.D. Red light flashes indicating it is
time to replace batteries with 4 new “C” batteries.
COURTESY MANUAL FLUSH BUTTON Allows
manual activation of flush when needed.
6
Use battery compartment wrench to remove
battery compartment tray. Pull cover off by rotating battery side forward
and out. Sensor Adjustor Tool comes in a built-in storage
pocket. Replace after use.
ADJUSTING YOUR E-Z FLUSH
STEP A STEP B STEP C
FV2001 Page 3