Zultys ZIP2, Руководство пользователя

Страница: 53 / 98

7. Using the Phone
45
7.6.1 Initiating a Conference Call
To initiate a conference call:
1. Make or answer the first call in the normal manner.
2. Press the Conference key combination (Func and ‘7’).
The phone places the first call on hold, selects the other call appearance, and provides you
with dial tone.
3. Dial the third person for the conference.
The phone reactivates the call that was on hold and joins all calls into a single call.
7.6.2 Terminating a Conference Call
7.6.2.1 Ending the Entire Conference
To end a conference call, go on hook. The phone terminates the calls on each of the call
appearances.
7.6.2.2 Dropping from the Conference
When one of the two parties leaves the conference call, the call appearance that was occupied by
the leaving party becomes available. If you drop out of the conference, all other calls in the
conference are terminated.
The Hold key does not work during a conference call.
7.7 Receiving a Page
To enable the ZIP2 to receive pages, perform the page provisioning procedure described in
section 5.3.4 on page 26.
Important
All page parameters must be entered as configured on your system or the ZIP2
will not receive any pages.
On the receipt of an incoming paging stream, the yellow LED is continuously lit and the audio
page announcement plays on the external speaker for the duration of the page.
7.8 Ending a Call
7.8.1 You Terminate the Call
You terminate a call by going on hook.
1
The phone ends the call, and silences the handset and
speaker.
1. See section 7.1.3 on page 39 for a definition of on hook.