Chapter 3 Installation and Preparation
Connection Type
Connection Description
Video input
source connection
The terminal supports simultaneous input of two channels of main video and
auxiliary video.
l
For the main video input, the built-in camera of the ZXV10 ET301 terminal is
recommended.
l
For the auxiliary video input, the connection is as shown at
C
. Connect the
HDMI IN
interface of the terminal to a video source device such as a PC.
Microphone
connection
Select any of the following microphones:
l
Built-in microphone: No connection is required. The ZXV10 ET301 terminal
has two built-in microphones, which are distributed on the left and right
sides of the front panel.
l
A100 digital microphone: The connection is as shown at
E
.
l
Linear microphone: Connect the 3.5 mm
TRS
interface to the linear
microphone.
Network
connection
Access either of the following networks:
l
Wired IP network: Connect the
LAN
interface of the terminal to the Ethernet.
l
WiFi network: Enable WiFi on the network setting page of the terminal.
3.2 Terminal Control Modes
The ZXV10 ET301 terminal supports two control modes: remote control mode and Web
mode. For the typical application scenarios of each mode, refer to
.
Table 3-2 Control Modes in Typical Application Scenarios
Operation
Remote Control Mode
Web Mode
Configuration and modification
o
o
Holding a conference
o
o
Multi-point conference control
o
-
Sending subtitles
-
o
Software maintenance
o
o
System diagnosis
o
o
l
Remote control mode: A user uses the terminal remote control to control the terminal.
Note:
If the remote control is insensitive, check its battery level.
3-3
SJ-20190419091840-001|2019-04-08 (R1.0)
ZTE Proprietary and Confidential
