Zte Z079584506204, Руководство пользователя

Страница: 9 / 24

6. Click Apply to confirm the settings.
7. Enable the Wi-Fi function on your device.
8. Select
on the Z289L device’s LCD screen to start the Wi-Fi Protected Setup
authentication process.
9. To respond to this authentication process, enable the WPS function on the
device you wish to connect.
10. Follow the system prompts on your device to finish the connection.
Using Push Button Configuration with WPS
Select
Settings
>
Wi-Fi Settings
>
WPS
. The WPS configuration is shown in the
following figure.
• PIN: Enter the PIN for the device you wish to connect.
• Push Button Configuration (PBC):
1. Select PBC in the WPS UI of the device you wish to connect.
2. Select PBC in the WPS page of the web UI and then click Apply .
3. Select on the device’s LCD screen and press the Enter Key to activate
your device’s WPS.
4. Select Next in your device’s WPS UI. After a few seconds your device can
access the WLAN, and the result will be shown in your device’s WPS UI.
Navigating Your Device
13 12
WPS
Select and press the Enter Key to launch Wi-Fi
Protected Setup.
Using the WPS
Setting Up Your WPS
If your computer or other Wi-Fi enabled device supports WPS, you don’t have to
input the password manually once your WPS has been set up in your web UI. To
set up, follow these steps:
1. Log into the web UI.
2. Select
Settings > Wi-Fi Settings > Basic Settings .
3. Enter the Network Name (SSID) or verify it is correct.
4. Enable
Broadcast Network Name (SSID) .
5. Set the Security Mode , Encryption Type , and Password (if needed). Refer to
the table below for settings.
Navigating Your Device
Security Mode Encryption Type Key Password WPS
OPEN NO ENCRYPTION No No No
OPEN WEP Yes No No
WPA2 (AES)-PSK Not Applicable No Yes Yes
WPA-PSK/WPA2-PSK Not Applicable No Yes Yes