Zoomlion ZRT850, Руководство оператора

Страница: 43 / 179

Operator’s Manual for Rough Terrain Crane
Op
erat
ing
co
nd
itio
ns and
po
int
s f
or at
te
nt
ion
CHAPTER 5 OPERATING CONDITIONS AND POINTS
FOR ATTENTION
5.1 OPERATING CONDITIONS
A. Always use the correct light diesel fuel and engine oil. Make your selection on the lowest
ambient temperature where you are to do the work. Refer to the table below for more data
on diesel and engine oil. Obey the Engine Manual if the data in this table is incorrect.
Table 5-1 Data on Diesel Fuel and Engine Oil
ENGINE EMISSION OIL BRAND SPECIFICATION
According to guidelines
per US EPA Tier 3
Emission Standards
Sulfur content < 15 PPM,
according to US EPA 2007
regulations
CH – 4 stage, API classification
According to guidelines
per EURO Stage III A
Emission Standards.
Sulfur content < 15 PPM,
according to EN 590
regulations.
CH – 4 stage, API classification
WARNING

The fuel sulfur content must be less than 15 PPM to obey US EPA Tier 3
Emission Standards.

The fuel sulfur content must be less than 15 PPM to obey EURO stage III A
Emission Standards.

Do not use fuel which is mixed with lubricants or accredited additives.
B. All mechanical components are in a break-in state during initial crane operation (less than
100 operating hours). You must follow the below instructions during this time period:

The working load and working speed must not be too high.

The maximum lift capacity should not be larger than 80% of the rate one.

Do not operate the crane at a speed that is more than the maximum limits.
C. Make sure that you do all of the work on level ground that is hard. The ground must hold
more than the load bearing capacity (permissible gro
und pressure ≥ 507.6 psi (3.5 MPa)).
Use material (such as wooden timbers) below the outrigger floats if the work area is soft or
not flat.
D. Before you operate a crane that uses the outriggers for support, make sure that the wheels
do not touch the ground. Before you use On tires lifts, make sure that you align the crane
wheels to the middle.
E. Do not operate the crane if the temperature at the job-site is more than -4°F to 104°F
(-20°C to +40°C).
5-1