Hitting the pads
produces sound, but
MIDI playback is not
possible.
54
Troubleshooting
No sound or
very low volume.
Check the following items first if there seems to be a problem with the RhythmTrak
•••
234.
Is supplied AC adapter connected
properly?
Connect AC adapter as described in
"Getting Connected" (page 3). Use only the
supplied AC adapter.
Make connections as described in "Getting
Connected" (page 3).
Try using another cable.
Check the system and make sure that the
volume level is adjusted properly.
Set the control to a suitable position.
Is [OUTPUT] jack connected
correctly to the playback system?
Is there a problem with the shielded
cable?
Is the connected playback system
operating normally?
Is [VOLUME] control of RhythmTrak
•••
234 set correctly?
Sound is distorted or
intermittent.
Is output level of RhythmTrak
•••
234 set too high?
Set [VOLUME] control of RhythmTrak
•••
234 to a suitable position.
Has volume been minimized with
[SOUND JAMMER] slider or FP01?
Increase volume with [SOUND JAMMER]
slider or FP01.
Song cannot be
recorded.
Is RhythmTrak
•••
234 set to mode
other than song mode?
Activate song mode (page 34).
Delete unneeded patterns and songs.
Is memory capacity limit reached?
[SOUND JAMMER]
slider has no effect.
Was parameter to be controlled by
[SOUND JAMMER] slider just
switched?
Immediately after switching [SOUND
JAMMER] slider control parameter, slider
has no effect until it is moved past the
currently active setting.
Symptom
Check
Remedy
FP01/FS01 has
no effect.
Is FP01/FS01 connected correctly
to [CTRL1 IN]/[CTRL2 IN] jack?
Make connections as described in "Getting
Connected" (page 3).
Use [FUNCTION] key and pad 9 (CTRL
ASSIGN) to select function (page 45).
Is desired function of FP01/FS01
activated?
Use [FUNCTION] key while pressing
pedal or switch of FP01/FS01 (page 45).
Was pedal or switch of FP01/FS01
not pressed when [FUNCTION] key
was used to set the function?
Troubleshooting
Is the MIDI receive function set to
ON?
Use the [FUNCTION] key and pad 13
(MIDI) to change the setting from "Int"
(MIDI receive disabled) to "Midi" (MIDI
receive enabled).