Zonar V4, Инструкция по установке и эксплуатации

Страница: 11 / 35

V4™
Installation/User Guide 11
General Housekeeping
1. Capture all drill chips during drilling operations. Do not allow drill chips to fall onto
electrical equipment, furnishings, heating ducts, etc. Magnets, sticky tape, vacuums,
physical barriers, etc. may all be used to accomplish this task.
2. Remove excess sealant. Sealant should be debris and contaminant free (for example,
no drill chips), consistent, and uniform in appearance.
3. Clip excess wire tie protrusions.
V4 Mounting Plate and Unit
To comply with FCC RF exposure requirements for mobile transmitting devices, this device
must be installed to provide a separation distance of at least 25 cm (10 inches) from all
persons. See General Guidelines .
The installation technician must record which V4 unit is being installed in each vehicle.
1. Find the GPS ID # on the back of the unit labeled “GPSID (S/N) 18xxxxxx.”
2. Record the asset (vehicle name) and the GPS being installed—this is important
information for Zonar Customer Care or the Ground Traffic Control Administrator.