Zonar V4, Инструкция по установке и эксплуатации

Страница: 9 / 35

V4™
Installation/User Guide 9
General Guidelines
The following is list of general guidelines for the installation process. It is important to read
these before starting.
Layout
•
V4 unit must be located a minimum of 25 cm (10 inches) from any person.
•
Do not place Zonar RFID tags, cables, or other equipment in any location or position
which may compromise human or equipment safety.
•
Verify placement acceptability with State DOT/Law enforcement prior to installation.
•
V4 has a temperature range of -40˚C (-40˚F) to +85˚C (+185˚F). Do not mount V4 in
hot engine compartments or near hot exhaust components.
• Lay all components out prior to installation to check for proper cable length and
interference issues.
•
Avoid mounting Zonar equipment, antennas and wiring near other radio equipment
(for example, two-way radios), PA equipment and high energy electrical sources (for
example, cables, relays, amplifiers, etc.).
Electrical
• Consult the vehicle’s manufacturer for specific installation guidelines. (HIGHLY
RECOMMENDED for Multiplex electrical systems)
• All power leads (red and white) must be connected to the vehicle’s protected circuitry
(for example, fuse panel, circuit breaker panel, protected circuits). Never electrically
connect Zonar equipment to unprotected circuits (for example, directly to battery).
•
It is also required that all power leads (red and white) be protected with a 3 to 5 amp
fuse and inline fuse holder (included) for optimal system protection.
• Electrical fuses should be installed as close as possible to the source of power.
• Do not connect to the 4 pin power input until all other V4 cables have been connected.