FR
EN
PL
NL
ES
PT
14
Non-Stimulation
Contacts (2ea.)
Enhanced contact
Points (2 ea.)
Contact Point Extension
Washer/Adjustement Tool
DESCRIPTION OF TRANSMITTER
Transmitter On/Off & Function Selection Switch
The On/Off & function selection switch has three functions. When the toggle
switch is in the up On/Off position, the unit will give the dog a pager/vibration
followed by stimulation correction. When the toggle switch is in the down
position, only a pager/vibration occurs (no stimulation). The power is off when
the toggle switch is set to the middle position.
1
On/Off Indicator Light
When the On/Off & function selection switch is either in the up or down position the On/Off
indicator light will be on, indicating that the power is on. When the switch is in the middle position
the light goes off, indicating that the power is off. The indicator light stays on even if a fuse is blown.
Field Width Adjustment Knob
This knob controls the width of the signal field (the approximate distance
from the boundary wire to the location where the receiver/collar first
activates). Turning the knob clockwise increases the field width, giving your
dog a wider area before the activation begins. Turning it counter-clockwise
decreases the signal field, thus giving the dog a shorter area prior to activation.
2
Boundary Wire Continuity Light
When the wires are connected properly, the boundary wire continuity light will be on. In the event
that the anti runaway fence wire becomes damaged or disconnected the light will automatically
turn off and the warning beep will sound.
Wire Connector Tabs
The easy-to-use push-release wire connectors let you instantly connect or
disconnect the boundary wire leads. Wires should have the plastic coating
stripped approximately a half-inch before being inserted into the red
connectors on the bottom of the wall mount transmitter.
The system comes with a ground wire to ground the unit. Strip about a half-
inch on each end of the ground wire and insert one end into the black
connector on the bottom of the wall transmitter. The other end should be buried into the ground
or wrapped around a water pipe and secured with electrical tape.
3
Power Jack
Plug the 220-volt adaptor into a 220-volt wall outlet and insert the adaptor plug into the power jack
of the transmitter.
1
2
3
On/Off Indicator
Light
On/Off &
Function
Selection
Switch
Boundary Wire
Continuity Light
Power Jack
Connector
for Ground
Wire
Boundary Wire
Connector Tabs
Field Width
Adjustement Knob
1 User manual
1 Training guide
