ZOLL WCD 3100, Руководство по обучению

Страница: 17 / 58

New patient setup
ZOLL Lifecor internal use only Page 4-1
4: New patient setup
About this section
y This section covers the basic procedures for setting up the monitor for each
new patient.
y This section applies to the WCD 3100 equipped with software version 5.1.
y If you need to change any other settings, see Appendix B on advanced
programming.
What you need to know
Programming the WCD 3100 is almost the same as programming the 3000. The
main difference is that you use the navigation buttons to move around the menus
and options.
Each time you fit a new patient, you’ll need to program the device with basic
patient information, same as with the 3000.
Programming the monitor for a new patient consists of entering the patient’s
name and the rate thresholds. In most cases, that’s all you’ll need to program. In
the rare case where you need to change any other settings, you will need to go
deeper into the programming.
Step-by-step instructions are provided on the following pages for the basic setup
for a new patient. Familiarize yourself with this procedure.
Step-by-step instructions for the more advanced programming are also provided
in Appendix B. Review this information so that you are somewhat familar with the
procedure and options if you ever need to make any changes.