6
4-OPERATING PROCEDURES & MAINTENANCE
1) Unpacking
1.Remove the exterior and interior packaging. Check if all the accessories are inside or
not. If any parts are missing, please contact our customer service.
2.Remove the tapes for fixing the door and inner cabinet, ice scoop, etc. Roughly clean
the inner cabinet & ice scoop with wet cloth.
3.Put the ice maker on a level & flat floor, without direct sunlight and other sources of heat
(like stove, furnace, radiator). Make sure that there is at least 20cm gap between the air
outlet and the obstacles, and at least 5 cm between Left/Right side and the wall.
4.Allow 4 hours for the refrigerant fluid to settle before plugging the ice maker in, as
the unit maybe fall upside down during shipping or transportation.
5.The appliance must be positioned so that the plug is accessible.
NOTE:Connect to the potable water supplying only. Only use drinking water.
NOTE:Connect to the potable water supplying only. Only use drinking water.
2) Cleaning Before First Using
1. Open the ice getting door.
2. Clean with diluted detergent, warm water and a soft cloth.
3.
Repeatedly clean the water contacting inner parts, you can pull the Water drain pipe of
the water tank indicating “H” in above illustration to drain the cleaned water in the water
tank, then next to clean inner ice-storing cabinet, till all of inner parts are cleanly, then
drain out all of the cleaned water from the water drain port located at unit back
indicating “7”in above illustration. And must to re-install back the water drain pipe of the
water tank and the cap of the unit water drain port, otherwise, the unit will not make the
ice normally.
Suggest that you should discard the ice-cube made by the first ice
making cycle after cleaning.
4. The outside of the ice maker should be cleaned regularly with a mild detergent solution
and warm water.
5.
Dry the interior and exterior with a clean soft cloth.
3) Installation location Requirement
1. This unit is not for outdoor use. Keep the proper room temperature and inlet water
temperature according to above specification table. Otherwise it will affect the ice making
performance.
2. This unit should not be located near any heat resource.
3. This unit should be located on a firm & level foundation at normal counter top height.
4. Do not put anything on the top of the ice maker.
5. To ensure proper ventilation for your ice maker, the front of the unit must be completely
unobstructed (at least 250mm free space). Allow at least 50mm clearance at rear, and
