13
NOTE: Do not use strong cleaning agents or abrasives on the interior,these
cleaners may transmit taste to the ice cubes,or damage and discolor the interior.
4) Ice Making Parts Cleaning
During the using, periodically to clean these main system of your ice-maker.
1. Repeat above step to clean the water tank and other inner parts of the unit.
2. Especially, to the water dividing pipe on the evaporator, when the compressor and the
water pump run normally, but if there is no water flowing out from the water dividing pipe or
the water flowing is very small, please discharge this water dividing pipe to clean carefully.
Clean each little holes on the
water dividing pipe displayed in
the following illustration, make
sure each hole is not clogged
by something, then install back
to the original location.
3. When there are ice cubes on
the surface of the evaporator,
but can’t fall down easily, do not
use the mechanical substance
to remove it by force. Only
press the “ON/OFF” button for
more than 5 seconds, the unit
will enter the ice melting
process, after some while, the big ice-cubes will fall down, then turn off the unit and unplug
the power cord to clean the surface of the evaporator.
4. For the water tank and ice-full detecting plate
1) The water tank and the ice-full detecting plate is also very important to keep your ice
cube hygienic. Put mixture of neutral cleaner & water into a clean water jet, then spray to
all the inner surface of tank & the ice detecting plate. Wipe these surfaces as far as
possible with a clean cloth.
2) And then, spray the surfaces with clean water, wiping with a dry clean cloth. Then drain
out the cleaned water in the water tank by
pulling out the Water drain pipe of the water
tank indicating
“
H
”
in above illustration. When
all of the cleaned water has been drained out,
to re-install back the water drain pipe of the
water tank.
NOTE:After cleaning the interior parts and
install back to its respective position, and
return machine to work, discard first batch
of ice.
