8
© Copyright 2019 Zoeller
®
Co. All rights reserved.
2. Standing near the Fit
, use your phone, tablet, or computer to look for the Fit’s SSID in your WiFi settings (see Figure
B
). It will look like “ZCTL_Fit_
xxxx” where “xxxx” is the first 4 digits of your Fit’s Device ID. Select this, and 2 things will happen:
1. The Z Control
®
LED will flash quickly.
2. A Z Control
®
setup screen will open after a few seconds.
If the setup screen does not appear, open a browser on the same device and type “192.168.125.1” in the address bar. If the setup screen appears but
is not used (cancelled or otherwise closed), the Fit will return to AP mode and the Z Control
®
LED will turn off until the next WiFi setup attempt.
3. On the setup screen (see Figure C), press the “WiFi Scan” button, scroll down to see the list of WiFi signals found, and choose the WiFi you want the
Fit to use for internet connectivity. Enter the password for the router you chose in the field indicated. If the password is correct, the Fit will connect to
the router and start sending status updates to zcontrolcloud.com. You will see the Z Control
®
LED go from blinking to solid. This could take up to a
minute or so.
If the LED does not turn solid, then the password entered is incorrect, the router’s security is insufficient (see note below**), or some other network
restriction is in place (see your network administrator). The Fit will return to standby mode if the connection to router is not successful. If you need
to force the Fit
into AP mode again, press the Z Control
®
button for 12 seconds. This will cause the Fit to re-enter AP mode and begin transmitting its
SSID again.
Select the Fit’s SSID
Click WiFi Scan button
Available WiFi will be listed here.
Select the one you want.
**Note that the Fit will not connect to routers with “WEP” or “OPEN” security.
Figure B
Figure C
Fit
