Connect to a Power Source
WARNING
Failure to comply with the following warnings can increase risk of fire or
electrocution which can result in property damage and serious injury, including
loss of life.
PREVENT ELECTRICAL SHOCK
• Keep the control unit at least 3.5 m from the edge of the pool.
• The cleaner is to be installed in accordance with the relevant requirements of the Aus-
tralian wiring rules AS/NZS 3000. Also refer to the installation instructions relating to the
swimming pool equipment for which the cleaner will be an integral part. The cleaner is
to be supplied through a Residual Current Device (RCD) with a rated residual operating
current of 30mA.
• Do not use an extension cord to connect the control unit.
• Do not allow anyone to swim while the cleaner is in
the pool.
• The control unit is water-resistant, not waterproof. In order to prevent electrocution,
never submerge the control unit or leave exposed to inclement weather.
1.
Unscrew the protective cap for the floating cable from the side of the control unit by
turning counter-clockwise (Figure 10).
Figure 10. Remove Protective Cap
2.
Grip the notched end of the floating power cable, insert into the control unit, and turn
clockwise to tighten. (Figure 11.)
Page
11
Zodiac
®
VX65iQ Robotic Pool Cleaner
|
Owner's Manual