![background image](http://html1.mh-extra.com/html/zodiac/vortex-pro-ec15-series/vortex-pro-ec15-series_owners-manual_4118509007.webp)
Figure 12. Attach Control box to Base
3.4 Connecting Floating Cable to Control
Box
WARNING
Failure to comply with the following warnings can
increase risk of fire or electrocution which can result in
property damage and serious injury, including loss
of life.
PREVENT ELECTRICAL SHOCK
• Keep the control box at least 3.5 m from the edge
of the pool.
• The cleaner is to be installed in accordance with
the relevant requirements of the Australian wiring
rules AS/NZS 3000. Also refer to the installation
instructions relating to the swimming pool equipment
for which the cleaner will be an integral part. The
cleaner is to be supplied through a Residual Current
Device (RCD) with a rated residual operating current
of 30mA.
• Do not use an extension cord to connect the control
box.
• Do not allow anyone to swim while the cleaner is in
the pool.
• The control box is water-resistant, not waterproof.
In order to prevent electrocution, never submerge
the control box or leave exposed to inclement
weather.
1.
Unscrew the protective cap for the power cable
from the side of the control box by turning
counter-clockwise (Figure 12).
3.3 Connecting the Control box to Caddy
(VX50 4WD / VX55 4WD) or Base
(VX40 /VX45 4WD)
VX50 4WD / VX55 4WD:
1.
Align the bottom of the control box with the
notch at bottom of the control box hook on the
caddy (Figure 10).
Figure 10. Align Control box with Caddy Hook
2.
Press control box onto the caddy hook until it
snaps and locks into position (Figure 11).
Figure 11. Attach the Control box onto Caddy
VX40 and VX45 4WD:
1.
Align the bottom of the control box with the
notch in the base (see Figure 12).
2.
Press control box down firmly to snap in place.
7
H0516700_REV C