Zodiac Edenpac 4D, Инструкция по установке и эксплуатации, Страница: 10 / 28

8
• the installation must be simple and allow for easy maintenance interventions.
• the appliance must be installed on a solid base (fastening centre distance 810 x 370) and protected against
flooding (using a « concrete » base with drain facility for condensation or installation of an additional condensation
evacuation kit placed at your disposal in the accessories sachet). The silent blocks supplied must be used, paying
attention not to compress them too much when tightening the fastening screws .
• the appliance must be level to allow for the gravitational evacuation of possible condensation produced during
operation.
• the blower must not be directed towards surrounding windows.
• vibrations and noise must not be transmitted to a building close by.
• the heat pump must be installed at a minimum distance from the end of the pool, as defined by the applicable
national electrical standards. In France, standard NF C 15 100 (section 702) specifies that the appliance must not be
installed less than 2 metres from the pool or water reserve, but may be installed between 2 and 3.50 metres if there
are not water jets. In the contrary case, respect a minimum distance of 3.5 metres.
Attention ! :
• Do not lift the appliance by picking it up at the front and/or the water inlet/outlet points . Use 2 lifting slings (not
supplied) placed on either side of the appliance (see drawing below). The handle on the right side may be used only to help
with the final positioning of the appliance.
• Do not install the heat pump close to an inflammable gas source.
• Do not install the heat pump close to a road or path to protect the appliance against mud splashing.
• Avoid places that are subject to strong winds, in particular if the wind blows against the appliance’s air outlet.
• The installation as well as electric and hydraulic connections must be carried out in compliance with applicable standards, in
particular standard NF C 15 100 for France (equivalent to CE I 364) .
• Keep the appliance out of reach of children.
To use the additional condensation evacuation
kit:
- Use the grooved elbow union and cap .
- The tank is equipped with two evacuation holes, one for the
cap
and the other for the grooved elbow union (their
position is interchangeable).
Note : To facilitate installation raise the unit 100 mm above
the ground with the additional blocks made of a hard,
water-resistant material (not supplied).
Slings