Zodiac DuoClear, Руководство по устранению неисправностей

Страница: 4 / 20

4
Circuit Breaker
Reset Circuit Breaker
1 . Turn off power supply .
2 . Find circuit breaker on bottom near power cord . Note : In some cases, insects may make nests
under edge of power pack – use caution .
3 . Push button in .
4 . Turn on power supply .
5 . If breaker continues to trip, replace breaker and PC board .
Replace Circuit Breaker
1 . Disconnect power supply .
2 . Remove 4 screws to remove cover .
3 . Disconnect ribbon wire connector from power PCB and set cover aside .
4 . Remove 2 push-on wire connectors from back of circuit breaker .
5 . Use pliers to squeeze base of circuit breaker and push through hole from the inside .
6 . Push new circuit breaker through hole from the outside till it snaps in place .
7 . Reconnect 2 push-on wires to back of circuit breaker .
8 . Reconnect ribbon wire connector to power PCB .
9 . Replace cover with 4 screws .
10 . Replace chlorinator on wall .
11 . Connect power supply .
Power Cord
Power Cord Replacement
1 . Disconnect power cord from power source .
2 . Remove 4 screws to remove cover .
3 . Disconnect ribbon wire connector from power PCB and set cover aside .
4 . Unscrew ground wire from back and disconnect the ground wire .
5 . Unscrew posts that attach 3 input wires and remove the fourth wire from the circuit breaker .
6 . Use pliers to squeeze base of power cord holder and push through hole from the inside .
7 . Unclip power cord holder and transfer to new power cord .
8 . Push power cord holder with new power cord through hole from the outside till it snaps in place .
9 . Reconnect all wires and screw ground wire to back .
10 . Reconnect ribbon wire connector to power PCB .
11 . Replace cover with 4 screws .
12 . Replace chlorinator on wall .
13 . Connect power cord to power source .