ZMC460N Motion Controller User Manual V1.5
⚫
For the common terminal, please select the "EGND" port on the power supply terminal
to connect to the "COM" terminal of the external input device. If the power supply of
the signal area of the external device and the power supply of the controller are in the
same power supply system, this connection can also be omitted.
3.4.2.
Basic Usage Method
(1)
Please follow the above wiring instructions for correct wiring.
(2)
After power on, please use any of the three interfaces ETHERNET, RS232 and RS485
to connect to ZDevelop.
(3)
State values of relative inputs can be read directly through “IN”
command, also, it can
be read through “ZDevelop/View/In”. Please refer to “ZBasic” for details.
(4)
Latch function can be set and opened through “REGIST” instruction, in software, use
REG_INPUTS to configure. Please refer to “ZBasic” for details.
Содержание ZMC460N
Страница 1: ......
